150 mm spiderweb arm with 90-degree stem clearance

Print two copies of Spiderweb-150mm-pivot90.stl and one M6-hand-knob.stl.
Use the jaw STL supplied here for printing. The .sc file is the editable SolidCraft model.
Print the jaws flat washer face down, cups up. Print the knob washer face down.
PAHT-CF starting profile: hardened 0.4 mm nozzle, 0.20 mm layers, five walls,
five top and bottom layers, 40% gyroid. Check supports in the slicer preview.

Hardware: one fully threaded M6 x 1.0 x 40 mm external hex-head bolt (10 mm across
flats), one plain M6 x 1.0 hex nut and one 6.4 x 18 x 1.6 mm flat washer.
Flip the second jaw about its long axis. Align the guides, seat the bolt head,
put the nut in the knob, then install the washer and knob.

The CAD sweep checked a 12 mm stem through 90 degrees in either direction
at both ends. Fit-check your base and bench-test grip with a dummy load
before trusting a tablet to the revised cups.
